SYSTEM CONNECTIONS
Compare this illustration with your generator to familiarize yourself with the location of these important connections:
Wiring for the 2 Pole Connector:
240 Volt Utility — Use to hook up the 240V utility leads from
the transfer switch to the generator.
Wiring for the 10 Pole Connector:
Fault Contacts — Use NO, COM and NC to hook up a siren,
light, etc. to alert you in case of a fault. Contacts reverse
state upon a fault condition.
All manuals and user guides at all-guides.com
FEATURES AND CONTROLS
10 Pole Connector
240 Volt Utility
12
Fault Contacts
Transfer Switch
Communication
Remote LED Output
+12 Volt DC, .5 Amp Output
2 Pole Connector
Remote LED Output — Use this to hook up the remote LED
supplied with the generator. The remote LED will turn on and
off in a series of blinks if certain faults are detected in the
generator.
Transfer Switch Communication — Use TxRx and TxRx GND
to transfer switch and optional wireless StatStation™ to
monitor generator functions.
+12 Volt DC, .5 Amp Output — Internal power supply.