auna DS-2 Mode D'emploi page 38

EN
38
• Recording will be completed only entire song being encoded, if
terminate the encoding process intermediately, there is no track being
recorded nor stored to the USB drive.
Copying of MP3 file
If putting an MP3 disc instead of a CD disc, the system will copy the files
to the USB or SD/MMC card if press the REC
procedures is same as CD encoding as stipulate on above, and the system
will switch to copying mode only if MP3 file being read.
Hints on copying
The system will create an "FCOPY" folder and then store all copy file in it.
Phono encoding
1. Select "PHON/AUX" mode and then press the REC
2. The LCD display (21) will show "
seconds. Now the system is starting the encoding mode.
3. Start playback at phono for the track which you want to record to USB
position.
4. After finish of recoding, press the STOP
LCD display (21) stops flashing and return to "PHON/AUX" mode.
Radio encoding
1. Select "TUNER" mode and then select the desire radio station.
2. Press the REC button (3) to start the encoding.
3. The LCD display (21) will show "
seconds. Now the system is starting the recording.
4. After finish of recoding, press the STOP
LCD display (21) stops flashing and return to "TUNER" mode.
Hints on radio encoding
• If the radio reception signal is not strong enough, the system cannot
start the encoding process and the text "NO GOOD" will show on the
LCD display (21).
• The recording quality and performance for radio encoding is not stable
due to interference of radio reception. This is not a malfunction of the
system.
• Radio mode will be turned to mono from stereo during encoding.
• Due to the interference, the sytem was not able to encode AM radio.
button (3). The operation
button (3) directly.
" and "REC" and is flashing after few
button (14) until the text on
" and "REC" and is flashing after few
button (14) until the text on