auna DS-2 Mode D'emploi page 32

EN
32
INSTALLATION AND OPERATION
Installation
• Unpack all parts and remove protective material.
• Do not connect the unit to the mains before checking the mains voltage
and before all other connections have been made.
• Do not cover any vents and make sure that there is a space of several
centimeters around the unit for ventilation.
Connections
• Connect the power cord (29) to AC outlet and connect the speaker jack
to the speaker socket (27) located on the rear side of unit.
• Press the power button (6) and if power LED indicator (5) lights up, it
means the power supply is normal. Now your system is ready to play
the music.
Setting the clock
1. Set unit in standby mode.
2. Press and hold the MEM/CLK-ADJ button (17), the LCD display (5) will
show "SET CLOCK" and then display "12 HR" or "24 HR". Press the SKIP
DOWN or SKIP UP
format (12 hr/24 hr). Press MEM/CLK-ADJ button (17) again to confirm.
3. The LCD (21) will display the first and second digit of "00" is flashing.
Press the SKIP DOWN
hour. Press MEM/CLK-ADJ button (17) to store the correct hour.
4. The third and fourth digit of "00" is flashing, press the SKIP DOWN
or SKIP UP button (2) to set the correct minutes. Then press "MEM/
CLK-ADJ" (17) to store the correct minute.
Note: The pre-set time will be reset completely if disconnecting the main
power supply. You are recommended to switch the system into standby
mode for convenience usage.
button (2) to select the appropiate area hour
or SKIP UP button (2) to set the correct