auna DS-2 Mode D'emploi page 37

ENCODING OF CD/PHONO INTO MP3 FILE
The system is able to encode normal CD or turntable to MP3 format and
recording at memory media with USB connecting port. Before starting the
encoding, please insert the memory media (USB pen drive) to the system
and make sure it had adequate free memory size for recording.
CD encoding
Encoding 1 track/1 disc
1. Perform normal playback of the CD track you want to encode and
record.
2. Press REC button (3) during the playback of the desired track and the
system will start encoding.
3. The system will show "
performing now.
4. Press the REC button (8) repeatly again to select record 1 track "REC_
ONE" or record one entire disc "REC_ALL".
5. After completing of recording, unit will stop playback automatically.
Encoding by program
1. Place a CD with the printed side facing up inside the tray and then close
the CD door.
2. Select the desire tracks by following "CD/MP3 disc programming"
procedures. Then press CD PLAY/PAUSE button (14) to start playback.
3. Press the REC button (8) and the unit will display "
and is flashing. Encoding is now performing.
4. Press the REC button (8) repeatedly again to select "REC_ALL".
5. After completing of encoding according to the preset program, unit will
stop playback automatically.
Hints on encoding
• The recording speed is 1:1 and according to the actual plying time of the
CD track.
• The system will create an "AUDIO" folder and then store the encoding
track in it.
• The recording format is preset at:
MP3 bit rate: 128 kbps, sampling rate: 44.1 kHz.
• No song title will be recorded during encoding mode.
• To interrupt the recording, press the STOP
recording mode.
" and "REC" and is flashing. Encoding is
button (14) during
" and "REC"
EN
37