Ugolini ARCTIC Compact 5L UL Carnet D'instructions page 7

5. 3. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components
in a dishwasher.
ATTENTION
Before any disassembly
procedure make sure that the dispenser is
disconnected from its power source.
1
Prepare at least two gallons of a mild
cleaning solution of warm (45-60 °C 120-140 °F)
potable water and dishwashing detergent. Do not
use abrasive detergent.
Important: if present, follow label directions, as
too strong a solution can cause parts damage,
while too mild a solution will not provide
adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser
use only a detergent suitable with plastic parts.
2
Using a brush, suitable for the purpose,
thoroughly clean all disassembled parts in the
cleaning solution.
ATTENTION
When cleaning the machine, do not allow
excessive amounts
electrically operated components of the unit.
Electrical shock or damage to the machine may
result.
3
Do not immerge the lighted top covers in
liquid. Wash them apart with the cleaning
solution. Carefully clean their undersides.
4
In the same manner clean the evaporator
plates using a soft bristle brush.
5
Rinse all cleaned parts with cool clean water.
and/or cleaning
of water around the
5. 3. 3 SANITIZING
D a i l y : S a n i t i z i n g s h o u l d b e p e r f o r m e d
immediately prior to starting the machine. Do not
allow the unit to sit for extended periods of time
after sanitization.
Sanitization must be performed whenever the
distributor is put back into operation with a new
product.
1
Wash hands with a suitable antibacterial
soap.
2
Prepare at least two gallons of a warm (45-
60 °C 120-140 °F) sanitizing solution (100 PPM
available chlorine concentration or 1 spoon of
sodium hypoclorite diluted with two litres of
water) according to your local Health Codes and
manufacturer's specifications.
3
Place the parts in the sanitizing solution for
five minutes.
4
Do not immerse the lighted top covers in
liquid. Carefully wash their undersides with the
sanitizing solution.
5
Place the sanitized parts on a clean dry
surface to air dry.
6
Wipe clean all exterior surfaces of the unit.
Do not use abrasive cleaner.
5. 3. 4 ASSEMBLY
1
Slide the drip tray into place.
2
Pinch tube faucet: push the dispensing
handle (1) and insert the pinch tube into its
vertical seat in the bowl bottom(2). Lightly pull
the pinch tube end downwards til itl is well
arranged (3) (see figure 4).
3
Gravity faucet: install the faucet handle and
7
figure 4