Ugolini ARCTIC Compact 5L UL Carnet D'instructions page 6

Arctic Compact 5-8 UL
4
The dispenser must be able to emit heat.
In case it seems excessive, check that no
heating source is close to the unit and air flow
through the slotted panels is not obstructed by
wall or boxes. Allow at least 15 cm (6") of free
clearance all around the dispenser.
In any case if the product in the bowls is cold the
unit is running properly.
5
How to reset beverage temperature:to reset
b e v e r a g e t e m pe r a t u r e p l e a s e ap p l y t o a
technician.
The proper temperature is preset at the factory.
5. 3 CLEANING AND SANITIZING
PROCEDURES
Cleaning and sanitizing of the dispenser are
recommended to guarantee the conservation
of the best product taste and the highest unit
efficiency. This section is a procedural
g u i d e l i n e o n l y a n d i s s u b j e c t t o t h e
requirements of the local Health Authorities.
Prior to the disassembly and cleaning, the
machine must be emptied of product.
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly
procedure make sure that the dispenser is
disconnected from
unplugging it or switching off the 2-pole wall
breaker.
1
Remove cover from the bowl.
2
Remove the empty bowl by lifting pulling
lever (1) and its front side (faucet side) up and
off bowl gasket (see figure 1).
figure 1
and/or cleaning
its power source by
3
Remove the bowl gasket.
4
Remove the pump impeller from its location.
5
Pinch tube faucet: push the dispensing
handle (1) and take the pinch tube off from its
seat (2) (see figure 2).
6
Gravity faucet: extract the piston and then
remove the dispensing handle (see figure 3).
7
Slide drip tray out and empty it.
6
figure 2
figure 3