Handling And Use; Radio Reset (Reset) - SilverCrest SAR 28 A1 Mode D'emploi

Display
♦
Radio station, time (automatically set with RDS reception), frequency and PTY set-
tings (these RDS functions are sent by broadcasting services in various volumes;
also refer to Section "Radio functions").
NOTE
►
GB

Radio reset (RESET)

To reset the device to its default factory settings, keep the RESET
pressed for about 6 seconds with a sharp object, such as a pen.
NOTE
►
Reset the device:
▯
▯
▯
▯
Settings using the SEL button (EQ/LD/TA/AF)
♦
The following settings are possible:
VOL - Volume (from 0 to 47)
BAS - Bass (from -7 to +7)
TRE - Treble (from -7 to +7)
BAL - Balance (sound distribution between the right and left speakers),
FAD - Fader (sound distribution between the front and rear speakers),
♦
104
All manuals and user guides at all-guides.com
Keep pressing the BD/DISP
displayed in turn:
If you are not receiving any RDS or PTY information, PTY NONE is shown on
the display.
To access the RESET button, the face plate must be completely removed,
see also Section "Removing the face plate".
when using for the fi rst time,
after connecting the cables,
when not all function buttons are working,
when an error message is shown on the display.
Press the SEL button on the device. The current volume level is shown.
18
Each further press of the SEL button accesses the next setting.
from 0L to 9L and 0R to 9R
from 0F to 9F and 0R to 9R
Turn the multi-controller
17
displayed.

Handling and use

button to have the following information
7
to change the settings of the menu item
22 button
SAR 28 A1