Attaching The Control Panel; Removing The Control Panel; Handling And Operation; Switching On And Off - SilverCrest SAB 160 B2 Mode D'emploi

Attaching the control panel

♦ First push the left-hand side of the control
panel into the frame, and angle it around
15° upwards.
♦ Then fi rmly press the right side until it locks
into place.
♦ Then fl ip the control panel upwards until it
locks into place.
Check to ensure that the control panel is fi tted cor-
rectly and is securely connected to the main device.
Not installing the control panel correctly can result
in malfunctions when using the device.

Removing the control panel

♦ Press the
panel. The control panel tilts automatically
forward.
♦ Incline the control panel around 15° upwards
and push it to the left. First pull the right-hand
side away, then the left-hand side.

Handling and operation

This section provides you with important information on handling and using the
device.
NOTE
► If no setting is confi gured and/or no button pushed within about 5 seconds,
the device returns to its previous operating mode. Changed settings are
saved.
Switching on and off
♦ Press the
display
♦ To switch off , press and hold the
appears on the display.
SAB 160 B2
button to release the control
briefl y to switch the device on. The WELCOME
button
/
19
is shown.
6
button until the notice GOOD BYE
/
GB
127