GB
Removing the device
Initial operation
Control panel
126
CAUTION
Possible damage to the cable
►
To avoid damage, keep an eye on the position of the cables when sliding
the device into the bay. Damaged cables can cause a fi re hazard!
♦
Carefully push the device into the installation bracket
place.
♦
After all connections have been made, activate the RESET button
a ballpoint pen or other pointed object.
♦
Attach the control panel as described in "Installing the control panel".
♦
Finally put on the bezel frame
To remove the installed device, proceed as follows:
♦
Remove the bezel frame.
♦
Insert the right and left keys
device. Ensure that the elevations on the spanners are facing outwards (the
tabs have now been bent back).
♦
Pull the device out.
You can remove the control panel from your device as an anti-theft measure.
Do not keep the control panel in your vehicle after removal.
NOTE
►
When the control panel is not inserted into the frame, the theft protection
LED
on the device blinks.
21
►
Always keep the control panel in its case
.
38
into their respective slots on the sides of the
40
to protect it.
37
until it locks into
39
with
23
SAB 160 B2