Radio Functions - SilverCrest SAB 160 B2 Mode D'emploi

Radio functions

Select frequency range
Automatic station search
Manual station selection
GB
Storing radio stations
Searching for stations with alternative frequencies
Selecting stored stations
134
♦ Press the BD/ENT button
medium wave (M 1, M 2).
♦ Press ▸▸I or I◂◂
2
The search stops when a station is found.
Hold down either ▸▸I or I◂◂ for two seconds, MANUAL appears on the
♦
display .
6
♦ Now press either ▸▸I or I◂◂ briefly to change the frequency in 0.05 MHz
(VHF) or 9 kHz (MW) increments until the required frequency is set.
If no button is pressed for approx. two seconds, the automatic station search is
set again. The display will read AUTO.
6 stations can be saved in each frequency range.
♦ Keep one of the 1/PAU to 6/FL+ buttons (
2 seconds to store the station currently selected. The numbers 1 to 6 will
appear on the display to indicate a successful save.
♦ Press the SCAN/REC button
the FM band range.
The search stops for 5 seconds at each station found and then continues.
♦ If you want to listen to and save the station, press the SCAN/REC button to
stop the search.
♦ Keep one of the 1/PAU to 6/FL+ buttons pressed for about 3 seconds to
store the currently selected station. The numbers 1 to 6 will appear on the
display to indicate a successful save.
♦ Select the frequency range with the BND/ENT button.
♦ Press one of the 1/PAU to 6/FL+ buttons to call up the stored station.
to switch between FM (F 1, F 2, F 3) and
15
briefl y to start an automatic station search.
17
to search for stations with an AF signal in
18
– ) pressed for about
14 9
SAB 160 B2