Handling And Use; Switching On And Off; Settings - SilverCrest SAR 28 A1 Mode D'emploi

Handling and use

This section provides you with important information on handling and using the
device.
NOTE
► If no setting is confi gured and/or no button pushed within about 5 seconds,
the device returns to its previous operating mode. Settings changed are saved.
Switching on and off
♦ Press the
is shown.
♦ To switch off , keep the
shown.

Settings

WARNING
Hearing damage as a result of too high a volume!
Setting the volume too high can result in permanent hearing damage.
► Set the volume to moderate levels only.
Volume
♦ Turn the multi-controller
Switching mute on / off
♦ Press the
appears in the display.
♦ Press the
celled when receiving a PTY or TA station or if you change station or source.
Operating mode
♦ Press the MD/PTY
card reader (CARD), USB port (USB) and audio input (AUX).
NOTE
The CARD and USB operating modes can only be enabled once the appro-
►
priate medium has been inserted.
SAR 28 A1
button to switch the device on. The WELCOME display
/MU
2
/MU button pressed. The GOODBYE display is
to set the volume.
17
/MU button briefl y to turn the sound off . The MUTE ON message
/MU button again to turn the sound on again. Muting is can-
3
button to switch between radio reception (TUNER),
GB
125