SilverCrest SAR 28 A1 Mode D'emploi page 131

Settings using the SEL button (EQ/LD/TA/AF)
♦ Press the SEL
Each further press of the SEL button accesses the next setting.
The following settings are possible:
BAS - Bass (from -7 to +7)
TRE - Treble (from -7 to +7)
BAL - Balance (sound distribution between the right and left speakers),
from 0L to 9L and 0R to 9R
FAD - Fader (sound distribution between the front and rear speakers),
from 0F to 9F and 0R to 9R
VOL - Volume (from 0 to 20)
♦ Turn the multi-controller
displayed.
Further settings using the SEL button (EQ/LD/TA/AF)
♦ Hold down the SEL button for about 2 seconds and then keep pressing the
SEL button until the required function is shown on the display.
♦ Turn the multi-controller to change the settings of the menu item displayed.
TA - Enabling / disabling Traffi c Announcement (traffi c information)
TA ON: If TA mode is enabled, the device immediately switches from other sta-
tions or operating modes to the radio station that is currently transmitting traffi c
information.
NOTE
► When the TA function is enabled, you can only search for or save stations
that are transmitting traffi c information. Stations that are transmitting traffi c
information signals are denoted in the display by TP.
TA OFF: The TA function is disabled.
AF - Enabling / disabling Alternative Frequencies
AF ON: When the AF function is enabled, the device searches for the current
station's optimum frequency.
AF OFF: The AF function is disabled.
EQ - Equaliser
Turn the multi-controller to select one of the FLAT, CLASSIC, ROCK, POP or
♦
EQ OFF settings. No equaliser is enabled if EQ OFF is set. The equaliser
setting is shown at the bottom of the display.
SAR 28 A1
button on the device. The current bass setting is shown.
18
to change the settings of the menu item
17
GB
127