Preparing The Unit; Brushing And Flossing - Waterpik Sonic-Fusion SF-01 Mode D'emploi

6
PREPARING THE UNIT / BRUSHING AND FLOSSING
Click
Bru sh Bru sh
Flo ss Flo ss
Click
Bru sh
Flo ss
Charge
Br us h
Fl os s
Bru sh
Flo ss
Blue
Light
Fill
Floss

Preparing the Unit

Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be
sure it is turned on.
Attaching the Brush Head to the Power Handle
Position the brush head on the power handle as shown. Press firmly until it clicks into
place. To remove, firmly pull the brush head to separate it from the power handle.
Attaching the Power Handle to the Hose
Position the power handle onto hose in the base. Press the power handle firmly onto
the hose attachment until it clicks into place. To remove, simply press the round
button on the back side of the power handle.
Charging the Sonic-Fusion®
Charge for at least 20 minutes before first use by placing the handle on the charging
base. For a full charge, leave the handle on the charging base for at least 4 hours. A
full charge should last 14 uses with a duration of 2 minutes each. If the toothbrush
is to be stored for an extended period of time (six months or more), be sure to fully
charge it (at least 4 hours) prior to storage.
Charge Lights
Toothbrush charge indicator lights will indicate level of battery charge for
approximately 10 seconds after removal from the charging base and after use, and
will then turn off. If only the bottom light is lit, then recharging is recommended to
ensure uninterrupted use.
Wireless Connection Light
Blue light indicates the flosser base unit is communicating via Wireless
Communication and is "Ready" for activation via FLOSS button.
Preparing the Reservoir
Remove reservoir and open hinged lid. Fill the reservoir with warm water. Close the
lid and replace the reservoir on the base and press firmly.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting No. 10), point the handle
and brush head into sink. Press the FLOSS button to turn water ON.
After water flows from the nozzle, press the FLOSS button to turn water OFF.