Care And Maintenance - Waterpik Sonic-Fusion SF-01 Mode D'emploi

8

CARE AND MAINTENANCE

Bru sh
Flo ss
Travel and Hose-Free Brushing
Toothbrush can be disconnected from the Sonic-Fusion® for travel or hose-free
brushing. Place the handle and desired brush head(s) in the provided case for
protection when traveling.
NOTE: To disconnect the toothbrush from the water hose, press the round button
on the back side of the power handle.
Using Mouthwash and Other Solutions
Your Waterpik® Sonic-Fusion® can be used to deliver mouthwash and antibacterial
solutions. After using any special solution, rinse unit to prevent clogging by partially
filling reservoir with warm water and running unit with brush head pointed into sink.
Care and Maintenance
Before cleaning, unplug from the electrical outlet.
After Each Use
1. After each use, when all functions are turned OFF, remove the brush head
from the handle and rinse brush head under running water.
2. Wipe the handle dry after each use.
General Cleaning / Removing Hard Water Deposits
• Clean the product when necessary by using a soft cloth and mild
non-abrasive cleanser.
• Hard water deposits may build up in your unit, depending on the mineral
content of your water. If left unattended, it can hinder performance. Cleaning
internal parts: add 2 tablespoons of white vinegar to a full reservoir of warm
water. Point the handle and brush head into sink. Turn Water Flosser ON and
run until reservoir is empty. Rinse by repeating with a full reservoir of clean
warm water. This process should be done every 1 to 3 months to ensure optimal
performance.
Toothbrush Low Charge Lock Out
The toothbrush charge indicator lights will flash if the battery charge is too low for
brushing. This may cause the toothbrush to enter Lock Out mode. To clear the Lock
Out, place the power handle on the charging base.
Leakage
If leaking due to a damaged hose, replacement hoses can be purchased at
www.waterpik.com or contact Water Pik Inc. customer service for a self service
repair kit.