Preparing The Unit; Brushing And Flossing - Waterpik Sonic-Fusion 2.0 SF-03 Guide De Démarrage Rapide

6
PREPARING THE UNIT / BRUSHING AND FLOSSING
Click
Brush Brush
Click
Brush
Floss
Speed
Floss
Speed Sonic–Fusion 2.0
Blue
Light
Fill
Brush
Floss
Speed
Sonic–Fusion 2.0
Floss
Rotate

PREPARING THE UNIT

Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch,
be sure it is turned on.
Attaching the Brush Head to the Power Handle
Position the brush head on the power handle as shown. Press frmly until it clicks into
place. To remove, frmly pull the brush head to separate it from the power handle.
Attaching the Power Handle to the Hose
Position the power handle onto hose in the base. Press the power handle frmly onto
the hose attachment until it clicks into place. To remove, simply press the round
button on the back side of the power handle.
Charging the Sonic-Fusion® 2.0 Power Handle
For a full charge, leave the handle on the charging base for at least 4 hours. If the
toothbrush is to be stored for an extended period of time (six months or more),
be sure to fully charge it (at least 4 hours) prior to storage.
Charge Lights
Toothbrush charge indicator lights will indicate level of battery charge for
approximately 10 seconds afer removal from the charging base and afer use, and
will then turn of. If only the bottom light is lit, then recharging is recommended to
ensure uninterrupted use.
Wireless Connection Light
Blue light indicates the fosser base unit is communicating via Wireless
Communication and is "Ready" for activation via FLOSS button.
Preparing the Reservoir
Remove reservoir and open hinged lid. Fill the reservoir with warm water. Close the
lid and replace the reservoir on the base and press frmly.
Prime Unit (First Time Use Only)
Point tip into sink. Press FLOSS button to turn water on. Rotate pressure knob
repeatedly between high and low until water fows. Afer water fows from the
nozzle, press the FLOSS button to turn water OFF.