Gaggia Milano CAREZZA Mode D'emploi page 35

13 Repeat the operations once again from step (8), for a total
of 4 tanks.
14 19 Remove the fi lter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
The descaling cycle is now complete.
At the end, press and hold the coff ee brewing and steam dis-
pensing buttons for 3 seconds: the descaling light turns off .
2 Refi ll the tank with fresh water. If necessary, prime the
circuit as described in section 4.6.
The descaling solution is to be disposed of ac-
cording to the manufacturer's instructions
and/or the regulations in force in the country of use.
13 "Intenza+" Filter (Optional)
The "INTENZA+" water fi lter can improve the quality of water.
Using the "INTENZA+" fi lter will prevent limescale from
building up and will ensure a much more intense aroma to
your espresso coff ee. We therefore recommend you install the
"INTENZA+" water fi lter, which can be purchased from your
local dealer or on-line at the Philips on-line store http://shop.
philips.com or at authorized service centres.
• Remove the small white fi lter from the tank and store
34
it in a dry place sheltered from dust.
• 32 Remove the "INTENZA+" water fi lter from its package.
Set the fi lter according to the water hardness.
• 33 Immerse the "INTENZA+" water fi lter vertically in cold
water (with the opening positioned upwards) and gently
press its sides to let the air bubbles out.
• 35 Put the fi lter into the empty tank. Press it until its limit
stop.
• Fill the water tank with fresh drinking water and reinsert it
into the machine.
Carry out the following steps to activate the "Inten-
za+" fi lter:
• 4 Press the ON/OFF button (11): the "
(16) lights turn on while the "
ing. Wait until the " " light (14) turns on steady.
• 5 Place a container or a tea glass under the steam wand
(Pannarello).
• Open the knob (3) by turning it clockwise.
• When about 1 litre of hot water has been dispensed,
6
close the knob (3) by turning it counter-clockwise.
• Empty the hot water container.
is a normal behaviour of the machine. Close the knob.
Wait until the (14) light is steady on before opening the
knob again.
Now the fi lter is active and the machine is ready for use.
" (12) and " "
" light (14) starts blink-
During this operation the pump is automatical-
ly disengaged and the (16) light is blinking: this
• 35 •