Feature Pack: B/W And Colour Units; Feature Pack - Advanced - Optelec ClearView+ Guide De L'utilisateur

All manuals and user guides at all-guides.com
+
Optelec ClearView User manual
/
5 Feature pack: B W and colour units
+
(The Feature pack is optional) If you are using the ClearView advanced
PC set, please refer to chapter 6, "Feature pack operation for PC units".
+
The Feature pack increases the functionality of the ClearView . Optelec
offers two Feature packs; Advanced and Basic. See the operation sheet
and below for an overview of the buttons.

Feature pack - Advanced

Semi colours
Pressing this button cycles you through 8 different foreground and
background colour combinations. You may choose to display text in a
pair of selectable colours when more contrast is needed or when
alternate colour combinations provide better visibility.
Note: This button can only be activated in one of the reading modes
and when a colour monitor is applied. When a B/W monitor is applied,
pressing this button will show a "non-available" sign on the screen.
Pointer (position locator)
Pressing this button will activate a LED dot, displayed on the centre
of the reading table. It indicates where the middle of the onscreen
image is located. Place a pen in the indicator light on the reading
table and you will see the pen displayed in the centre of the image
on your screen.
Switch between internal camera and PC / external source
If a PC or other external Optelec source is connected to the
+
ClearView , press this button to switch between the internal camera
image and the PC / external source. In other cases, pressing this
button results in a full screen camera image.
Positioning of lines / windows
When line markers or the windows are activated (see further), turning
this knob will change the position of the line markers / windows on the
screen. Line markers and windows can either be displayed in a
horizontal or vertical position depending on the status of button .
Page 8 of 15