Safety And Care - Optelec ClearView+ Guide De L'utilisateur

Optelec

2 Safety and care

Read these instructions carefully before setting up your system. Keep this
user manual as a guide for future reference.
• Use the ClearView
changes in temperature or humidity. Do not place ClearView
radiator or heater, or where it will be exposed to direct sunlight. These
conditions may cause damage to the unit's electronics or optics.
• Do not place this system on an unstable surface. It may fall, causing
serious damage to the unit or injuries to the user.
• If using your own monitor on top of the ClearView
does not weigh more than 16 kg, or is larger than a 20"screen. The
monitor platform is designed to hold a maximum of 16 kg.
• Grip on the monitor firmly when adjusting it in place to guarantee stability
of the entire system.
• The X/Y table and monitor contain moving parts. Please take care when
adjusting the screen position and operating the X/Y table. Injury may occur
if fingers or lose items of clothing are caught in the operating mechanisms.
If you have difficulty in operating the unit safely, please seek advice or
contact your supplier.
• Contact your dealer to service this equipment if necessary. Do not open
your unit as it will void the warranty.
• If moving the ClearView
the Base unit for safe and easy transport. Carry the ClearView
by the two recessed grips at both sides of the Base unit table.
• Always turn the power off when the system is not in use.
• Always unplug the system before cleaning. Use a soft damp cloth to clean
the exterior. Do not use cleaning agents or abrasive materials as they will
damage your unit.
• Use only the power adapter provided.
All manuals and user guides at all-guides.com
+
indoors. Do not expose the unit to extreme or rapid
+
to another location, disconnect the monitor from
+
ClearView User manual
+
near a
+
system, be sure that it
+
Base unit
Page 4 of 15