Tractel Davimast Manuel D'installation, D'entretien Et D'emploi page 14

A li eli e that re uires the i stallatio structure ot to
ha e a stre th a o e 1
coefficie t, ca
each e uipped with a 1 0 k
GB
with 360° rotation bracket (e.g. a Tractel
temporary lifeline).
IMPORTANT: The operators must ensure their fall
arresters never cross during use.
6 .2 . loc o
A ter a all, the mecha ism o the Bloc or
To e acuate the operator up or dow , e
recovery mechanism by pushing the lock button and
then operate the crank.
The self-retracting fall arrest system Blocfor™
a d 30 is e uipped with two ha dles to acilitate its
handling and use in rescue by lifting by holding the
e uipme t ha dle with o e ha d a d the cra k ha dle
with the other.
For information on how to use the Blocfor™
30 de ice i all arrest mode, see the Bloc or
360 instructions.
The connection with the PPE anchor point on the
Davimast Blocfor™
EN 362 connector. Up to one operator weighing up to
150 kg can connect to this bracket at the same time.
6 .2 .1 . e c e ope ation
6.2.1.1. Activating the recovery function
See Figure 4.1.
• (1) Press the red lock button to engage the recovery
function; and
• (2) Pull and turn the crank to recover the operator:
• Clockwise to go up; or
• Anti-clockwise to go down.
6.2.1.2. Return to the fall arrest function
6.2.1.2.1. R e w i n d i n g t h e c a
See Figure 4.2.
he the reco ery is complete, rewi d the e tire ca le
into the unit by turning the crank clockwise.
DANGER: Do not disengage the recovery function
from the unit if the cable is not fully wound in the
housi , otherwise the ca le may rewi d itsel at hi h
speed.
6.2.1.2.2. D i s e n g a g i n g t h e r e c o
See Figure 4.3.
14
k , i cludi
e i stalled etwee two
PP dou le a chor
an
R bracket must be made using an
it t e loc o
b l e i n t h e d e v i c e
v e r y f u n c t i o n
• To dise
a y sa ety button (1) and the crank shaft (2) simultaneously;
a imasts, • Make sure that the crank handle is positioned
ertically, with the ha dle at the top so that this
Tempo 3 operation can be carried out; and
®
• Pull the handle (3) before folding it back (4).
DANGER:
Any lifting operation with the Blocfor™
The winch system is intended for rescue operations
only.
is locked.
a e the
6 .3 . a ol
For information on how to use the Carol™
a li ti operatio , see the ma ual
20R
hand winch with worm screw" .
The connection with the PPE anchor point on the
Davimast Carol™
EN 362 connector. Up to one operator weighing up to
150 kg can connect to this bracket at the same time.
20R and
The following are strictly prohibited:
• Installing or using this product without proper
permissio , trai i
without the super isio o a authorised, trai ed a d
accredited supervisor;
• Using this product if any of the markings are illegible;
• stalli
it thoroughly;
• Using this product if it has not undergone a periodic
inspection within the past 12 months by a technician
who has permitted its reuse in writing;
• Connecting a fall arrest system if any of its
components has not undergone a periodic inspection
within the past 12 months by a technician who has
permitted its reuse in writing;
• Using a Tractel
applications other than those described in these
instructions;
• Using this product in contradiction with the information
speci ed i the sectio
• si this e uipme t as a all arrest a chor de ice
or more operators tha speci ed i para raph 4.2
• si this product i the wei ht o the operator,
i cludi
• Using this product with a load ranging from 100 kg to
1 0 k
tools) if any component in the fall arrest system has a
lower safe working weight;
• Using this product if it has arrested a fall;
• Using this product in a highly corrosive or explosive
atmosphere;
a e the wi ch mecha ism, press the red
TS
TS bracket must be made using an
7 . o i ite
a d accreditatio or, aili
or usi this product without rst eri yi
fall arrest anchor device for any
®
13. i espa
e uipme t a d tools, e ceeds 1 0 k
total wei ht o the operator, e uipme t a d
R is prohibited.
TS winch for
arol TS type
e
that,