Tractel Davimast Manuel D'installation, D'entretien Et D'emploi page 13

The arol TS racket is e uipped with a
795:2012 class A 150 kg anchor point for securing one
operator operating the Carol™
NOTE: The Carol™
lower or raise an operator.
The Carol™ TS hoist is suitable for handling and
securing loads with an SWL of up to 250 kg.
5 . n tallation
NOTE: whe the
plate attached to the structure, do ot use the a imast
i there is a y dou t a out the
supporting structure or base plate fasteners.
5 .1 . n tallin t e avi a t
The operator must rst e protected rom the risk o
falling before any installation work.
The Davimast mast may only be installed on Tractel
Davitrac and Davimast permanent base plate.
Setting up the Davimast on the base plate (Fig. 2):
• Install the Davimast (M) in a Tractel
• epe di o the ase plate, t the mast rotatio lock
pin (P).
The a imast is i place, ready to recei e a racket
see 5.3.
5 .2 . i antlin t e avi a t
The operator must rst e protected rom the risk o
falling before any dismantling work.
To disco ect the a imast rom its ase plate, remo e
the a imast racket, the
• epe di o the ase plate, remo e the mast
rotation lock pin (P); and
• Remove the Davimast (M) from the Tractel
plate.
The Davimast is ready to be transported.
5 .3 . n tallin a ac et on t e avi a t
a t
NOTE The a imast mast must e e uipped
with a Tractel Davimast anchor bracket for one of the
®
ollowi rackets Bloc or
PPE double anchor with 360° rotation.
o other co uratio is permitted.
TS hoist.
TS hoist may not be used to
a imast tted with a ase
uality or type o
base plate; and
®
base
®
, arol TS or 1 0 k
Once the Davimast is in place:
1. Install the bracket on the Davimast mast (Fig. 3).
Each bracket has a positioning pin that prevents the
chosen system from being set up incorrectly. Each
racket must e
to the bracket. This does not include the double
a chor poi t racket which is e uipped with o ly
one pin; and
2. Lock the bracket with the pin and locking pins
attached to the bracket (Fig. 3).
NOTE: It is strictly forbidden to modify the
anchoring brackets supplied with the system in any
way.
The Davimast is ready to be used.
5 .4 . n tallin a all p otection evice on
a avi a t anc o point
The rackets are tted with a PP a chor poi t.
Two fall protection systems must never be connected to
®
the same anchor point. A lifting system must never be
connected to the PPE anchor point.
The connection with the PPE anchor point on the
Davimast must be made using an EN 362 connector.
DANGER: The presence of a second operator
nearby is essential to carry out a possible evacuation.
The rescue operations to be planned must have been
studied e oreha d i
resources a d e uipme t to e used to rescue the
i ured perso withi a period o less tha 1 mi utes.
A ter that time, the operator is i da
Throu hout the rescue phase, there must
direct or indirect visual contact or other means of
communication between the rescuer and other
persons involved in the rescue.
6 .1 .
otation
The 150 kg PPE double anchor with 360° rotation
secures 1 operator by rotating anchor with a maximum
weight of 150 kg. Up to two operators can connect to
this bracket at the same time.
Each anchor point turns 360° independently.
The connection with the PPE anchor point on the
Davimast must be made using an EN 362 connector.
ed with the two pi co
6 . Use
order to de e the huma
er.
o le anc o it
GB
ected
e
13