Tableau Des Alarmes - Tecno-gaz TD010TMD Mode D'emploi

Mode d'emploi

9.6 Tableau des alarmes

ALARME
E00 EEPROM ALARM
E01 BLACKOUT
E02 DOOR OPEN
E07 NO LOCKED DOOR
E09 NO UNLOCKED DOOR
E11 DIRTY WATER
E20 NO COLD WATER
E21 NO HOT WATER
E22 NO DEMI WATER
E26 PRINTER ERROR
E30 FLOWMETER 1
E31 FLOWMETER 2
E32 FLOWMETER 3
E34 PRODUCT TIMEOUT
E41 DRAIN TIMEOUT
E43 DRY TEMPERATURE
DESCRIPTION
Firmware installed successfully.
A blackout occurred during cycle
execution and the program was stopped.
The door is open or unlocked.
Close the door.
The door did not lock within the set
time.
The door did not unlock within the set
time.
Check for dirt on the load and check the
inlet demineralized water.
The cold water tap could be closed or
partially open. Check it.
The hot water tap could be closed or
partially open. Check it.
The demineralized water tap could be
closed or partially open. Check it.
The printer is turned off, unplugged or
out of paper. Check it.
Chemical liquid tank 1 might be empty.
Check it.
Chemical liquid tank 2 might be empty.
Check it.
Chemical liquid tank 3 might be empty.
Check it.
The density of the chemical liquid might
be too high. Check it.
The drain pipe might be blocked or
clogged. Check it.
The load might not be dried because the
minimum set temperature has not been
reached.
ACTION
1-Appuyer sur RÉINITIALISER
2-Installer nouveau jeu de
données
Appuyer sur RESET
Appuyer sur RESET
Si elle persiste appeler le tech-
nicien.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Check if the safety floatswitch
has not tripped.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
Press RESET
If it persists, call the technician.
49