BFT P7 Instructions D'utilisation Et D'installation page 3

Thank you for buying this product, our company is sure that you will be more than satisfied with the product's performance. The product is supplied with a "War-
nings" leaflet and an "Instruction booklet". These should both be read carefully as they provide important information about safety, installation, operation and
maintenance. This product complies with the recognised technical standards and safety regulations.We declare that this product is in conformity with the following
directives: CAN/CSA-C22.2 No. 247-92 UL Std. No. 325 (Certificate: 1002906 Date Issued: October 16, 2000).
1) GENERAL OUTLINE
A compact sturdy hydraulic piston, available in various versions according to the user's requirements and type of operating. All models are supplied without locks
(reversible), and an electric lock is required to keep them blocked. To make the manual manoeuvre easier, the lock can be released by means of a knob which can
be reached using the appropriate key. The pushing force is adjusted with extreme precision by means of two by-pass valves which provide antisquash safety. The
end-of-stroke operation is electronically set in the control panel by means of a timer. All models are available with slow-down function during the closing .
2) SAFETY
If correctly installed and used, this automation device satisfies the required safety level standars. However, it is advisable to observe some practical rules in order to
avoid accidental problems. Before using the automation device, carefully read the operation instructions and keep them for future reference.
• Keep children, persons and things outside the automation working area, particularly during its operation.
• Keep radio control or other control devices out of children's reach, in order to avoid any unintentional automation activation.
• Do not intentionally oppose the leaf movement.
• Do not attempt to open the gate manually, if the electric lock has not been released by means of the appropriate key.
• Do not modify the automation components.
• In case of malfunction, disconnect the power supply, activate the emergency release to have access t the automation and request the assistance of qualified
technician (installer).
• Before proceeding to any outside cleaning operation, disconnect the mains power supply.
• Keep the photocell optical components and light signal devices clean. Check that the safety devices (photocells) are not obscured by branches or shrubs.
• For any direct assistance to the automation system, request the help of a qualified technician (installer).
• Have qualified personnel check the automation system once a year.
3) EMERGENCY MANOEUVRE
In case of emergency, for example when the electrical power is disconnected, open the electric lock by means of the appropriate key to release the gate, and open
the leaf manually; you may also reach the release knob to facilitate the manoeuvre. In order to get access to the release knob, move the small cap in the direction
indicated by the arrow (fig.1) to reveal the lock, insert the key, turn it clockwise by 90° and lift the entire release cover by pulling with the key. The knob must be
allowed to turn as far as possible in the direction indicated by the arrows. OPEN to release: the gate can be opened manually with ease. CLOSE to lock : turn the
knob clockwise until it is completely locked, and so restore the actuator electrical operation. The electric lock can also be used to keep the block of the gate in case
of actuator malfunction or current failure.
www.metalines.com
USER'S MANUAL
Fig. 1
ENGLISH
3
P7 - P4.5 -
sales@metalines.com