Scheppach AB1900 Traduction Des Instructions D'origine page 35

Causes are:
• Pressure points when power supply cables are routed through the window or door gaps.
• Bends due to improper fastening or guiding of the power supply cables.
• Interfaces by running over the power supply cables.
• Insulation damage by pulling off the wall outlet.
• Cracks due to ageing of the insulation.
Such defective power supply cables must not be used and are extremely dangerous to
life because of the insulation damage!
Check power supply cables regularly for damage. Make sure that the power cable is not
connected to the mains supply when you check.
Electrical connections must comply with the relevant VDE and DIN regulations. Only use
connecting cables with H 07 RN-F mark.
An imprint of the type designation on the power cable is mandatory.
AC motor
• The mains voltage must be 230 V ~ / 50Hz
• Extension cables up to 25 m length must have a cross section of 1.5 mm
Power supply and extension cord must be 3-wire = P + N + SL. - (1/N/PE).
The mains supply is secured up to 16 A.
• The product meets the requirements of EN 61000-3-11 and is subject to special connec-
tion conditions. This means that use of the product at any freely selectable connection
point is not allowed.
• Given unfavorable conditions in the power supply the product can cause the voltage to
fluctuate temporarily.
• The product is intended solely for use at connection points that have a continuous cur-
rent-carrying capacity of the mains of at least 100 A per phase.
• As the user, you are required to ensure, in consultation with your electric power company
if necessary, that the connection point at which you wish to operate the product meets
the requirement named above.
Connections and repairs of electrical equipment may only be carried out by an electrician.
Please provide the following information in the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
www.scheppach.com
.
2
GB | 35