Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
2 - INTRODUCING THE PRODUCT
2.1 - Product description
Irreversibile electromechanical gearmotor for sliding gates weighing
2.2 - Set panel and and technical characteristics
TECHNICAL DATA
Speed*
Torque
Working cycle
Control unit
Power
Motor consumption
Absorbed power
Capacitor
Thermoprotection
Protection degree
Dimensions (L-P-H)
Weight
Working temperature
Max gate weight
* Variable data according to gate weight
LIMIT USE: The limit use refer to the recommended weight (about
2/3 of maximum allowed weight). Use with maximum allowed weight
could reduce the above performance specifications in tecnhical
data. The working cycle, operating times and number of consecu-
tive cycles are merely approximate. These have been statistical-
ly determined in average conditions of use and are not certain for
each single case. They refer to the period when the product ope-
3 - PRELIMINARY CHECKS
Before installing this product, verify and check the following steps:
- Check that the gate or door are suitable for automation
- The weight and size of the gate or door must be within the maxi-
mum permissible operating limits specified in Fig. 2
- Check the presence and strength of the security mechanical stops
of the gate or door
- Check that the mounting area of the product is not subject to flo-
oding
- Conditions of high acidity or salinity or proximity to heat sources
could cause malfunction of the product
- Extreme weather conditions (for example the presence of snow,
ice, high temperature range, high temperatures) may increase the
friction and therefore the force required for the handling and initial
10
up to 2500 kg at 230 Vac.
SC202MHD
cm/s
17
Nm
93
%
50/70*
CT102I
Vac
230
A
4
W
920
µF
25
°C
150
IP
44
mm
360-270-390
kg
25
°C
-20+55
kg
2000
rates without the need for special maintenance.- Each automatic
entrance features variable factors such as: friction, balancing and
environmental conditions that can substantially change both the du-
ration and operating quality of the automatic entrance or part of its
components (including automatic system). It is up to the installer to
adopt adequate safety coefficients for each single installation.
starting point may be higher than under normal conditions.
- Check that the manual operation of gate or door is smooth and
friction-free and there is no risk of derailment of the same
- Check that the gate or door are in equilibrium and stationary if left
in any position
- Check that the power line to supply the product is equipped with
proper grounding safety and protected by a magnetothermal and
differential security device
- Provide the power system with a disconnecting device with a gap
of contacts enabling full disconnection under the conditions dictated
by the overvoltage category III.
- Ensure that all materials used for the installation comply with cur-
rent regulations
SC252M
17
110
30
CT102I
230
4
920
35
150
44
360-270-390
24
-20+55
2500
Publicité
Chapitres
Table des Matières
