Machine Installation; Uncrating Machine; Installing Batteries - Nobles Speed Scrub 2601 Opérateur Manuel Et Liste Des Piéces

MACHINE INSTALLATION

UNCRATING MACHINE

1. Carefully check carton for signs of damage.
Report damages at once to carrier.
2. Check Carton Contents list, contact distributor for
missing items.
Carton Contents:
-- Machine, Model No. 1002193
-- 24DC/120AC, 20A Battery Charger (#603235)
-- 2 -- 12V, 215 AH Batteries (Installed)
-- 2-- Cylindrical Brushes
-- Squeegee Assembly
3. To uncrate the machine, remove the rear and front
shipping brackets that secure the machine to the
pallet. Remove the rear 4x4 board from the pallet
and carefully back the machine off the pallet. The
pallet will tip downward creating a ramp. Make
sure the scrub head is in the raised position.
ATTENTION: Do not push machine off pallet edge,
machine damage may occur.

INSTALLING BATTERIES

WARNING: Keep Sparks And Open Flame
Away. Keep Battery Hood Open When Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and safety glasses when
handling batteries or battery cables. Avoid contact
with battery acid.
Recommended Battery Specifications:
Two 12 volt, deep cycle, 215 A hour batteries.
Maximum battery dimensions are 7 in / 178 mm W x
15 in / 381 mm L x 14 in / 356 mm H.
1. Park the machine on a level surface and turn all
switches to the OFF position.
2. Hinge open recovery tank to access battery
compartment. Make sure recovery tank is drained
before opening (Figure 1).
Speed Scrub 2601 Cylindrical Brush (06- -06)
Home Home Find... Go To.. Find... Go To..
FIG. 1
3. Carefully install batteries into battery tray at
bottom of compartment and arrange battery posts
as shown (Figure 2).
FIG. 2
ATTENTION: Do not drop batteries into
compartment, battery and machine housing
damage may result. This damage in not covered
by warranty.
4. Before connecting battery cables, make sure
terminals and posts are clean. Use a post cleaner
and wire brush if necessary.
NOTE: Apply a light coating of non-metallic grease or
protective spray on the cable connections to prevent
battery corrosion.
5. Connect cables to battery posts as shown (Figure
2), RED TO POSITIVE & BLACK TO NEGATIVE.
Use the rubber boot post protectors supplied.
6. After batteries are properly installed, check battery
meter charge level. The machine must be in full
operation for an accurate reading (See MACHINE
OPERATION). Charge batteries if needed.
OPERATION
7