Safety Precautions - Nobles Speed Scrub 2601 Opérateur Manuel Et Liste Des Piéces

OPERATION

SAFETY PRECAUTIONS

This machine is intended for commercial use. It is
designed exclusively to scrub hard floors in an
indoor environment and is not constructed for any
other use. Use only recommended commercially
available floor cleaners intended for machine
application.
All operators must read, understand and practice
the following safety precautions.
The following warning alert symbol and the "FOR
SAFETY" heading are used throughout this manual as
indicated in their description:
WARNING: To warn of hazards or unsafe
practices which could result in severe personal
injury or death.
FOR SAFETY: To identify actions which must be
followed for safe operation of equipment.
Failure to follow these warnings may result in:
personal injury, electrocution, electrical shock,
fire or explosion.
WARNING: Fire Or Explosion Hazard:
- - Never Use Flammable Liquids Or Operate
Machine in Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with explosion proof
motors. The electric motors will spark upon start
up and during operation which could cause a flash
fire or explosion if machine is used in an area
where flammable vapors/liquids or combustible
dusts are present.
- - Do Not Pick Up Flammable Materials Or
Reactive Metals.
- - Batteries Emit Hydrogen Gas. Keep Sparks
And Open Flame Away. Keep Battery
Compartment Open When Charging.
WARNING: Electrical Shock Hazard.
Disconnect Battery Cables Before Servicing
Machine.
WARNING: Spinning Brush. Keep Hands
Away. Turn Off Power Before Working On
Machine.
4
Home Home Find... Go To.. Find... Go To..
The following information signals potentially
dangerous conditions to the operator or
equipment:
FOR SAFETY:
1. Do not operate machine:
- - With flammable liquids or near flammable
vapors as an explosion or flash fire may
occur.
- - Unless trained and authorized.
- - Unless operation manual is read and
understood.
- - If not in proper operating condition.
2. Before starting machine:
- - Make sure all safety devices are in place
and operate properly.
3. When using machine:
- - Go slow on inclines and slippery surfaces.
- - Wear no- -slip shoes.
- - Use care when reversing machine.
- - Report machine damage or faulty
operation immediately.
- - Never allow children to play on or around.
- - Follow mixing and handling instructions
on chemical containers.
4. Before leaving or servicing machine:
- - Stop on level surface.
- - Turn off machine.
5. When servicing machine:
- - Avoid moving parts. Do not wear loose
jackets, shirts, or sleeves.
- - Use hoist or jack that will support the
weight of the machine.
- - Block machine tires before jacking up.
- - Wear eye and ear protection when using
pressurized air or water.
- - Disconnect battery connections before
working on machine.
- - Wear protective gloves and safety glasses
when handling batteries or battery cables.
- - Avoid contact with battery acid.
- - Use manufacturer supplied or approved
replacement parts.
- - All repairs must be performed by a
qualified service person.
- - Do not modify the machine from it's
original design.
Speed Scrub 2601 Cylindrical Brush (12- -02)