Resetting The Password Function; Disabling The Password Function - Pioneer PureVision PDP-506XDE Mode D'emploi

Useful Adjustment Settings

Resetting the password function

1
Press HOME MENU.
2
then ENTER).
Select "Setup" ( /
3
Select "Password" ( /
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
4
then ENTER).
Select "Reset" ( /
5
then ENTER).
Select "Yes" ( /
6
Press HOME MENU to exit the menu.
NOTE
• The above procedure will reset the password to the factory
default (1234).

Disabling the password function

Use the following procedure if you want to deactivate the
protection function that prompts password entry.
1
Press HOME MENU.
2
then ENTER).
Select "Setup" ( /
3
Select "Password" ( /
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
4
Select "Password Setting" ( /
5
then ENTER).
Select "Disable" ( /
6
Press HOME MENU to exit the menu.
NOTE
• The above procedure will reset the password to the factory
default (1234).
• After disabling the password function, you cannot change
the Child Lock settings. For the Child Lock, see page 43.
• After disabling the password function, you cannot change or
reset the password.
• When you enable the password function again after
disabling it, the factory default password (1234) is restored.
We suggest you write down your password so you don't forget it.
PDP-506XDE/PDP-436XDE
Your password No.:
then ENTER).
then ENTER).
then ENTER).
If you forget the password
When the message "Please Input Your Password" is
displayed in step 3 under "Changing the password" (page
58), "Resetting the password function" (page 59), or
"Disabling the password function" (page 59), press the
ENTER button on the remote control unit and hold it
down for 3 seconds or longer.
The password reverts to "1234".
12
59
En