Useful Adjustment Settings; Switching The Vertical Drive Frequency (Av Mode Only); Adjusting Image Positions (Av Mode Only); Adjusting Image Positions And Clock Automatically (Pc Mode Only) - Pioneer PureVision PDP-506XDE Mode D'emploi

Useful Adjustment Settings

12
Useful Adjustment Settings
Switching the vertical drive frequency
(AV mode only)
You can switch the vertical drive frequency for screen display
between 75 Hz and 100 Hz. Choose the drive frequency that
better suits your broadcasting signals.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Drive Mode" ( /
4
Select "75 Hz" or "100 Hz" ( /
Drive Mode
75Hz
100Hz
5
Press HOME MENU to exit the menu.
NOTE
• This setting can be made for each input source separately.
• This setting cannot be made when 480i, 480p, 1080i@60Hz,
720p@60Hz, or 1080p@24Hz signals are input.
• If you select "Auto" for "Side Mask" (page 57), the selection
for "Drive Mode" becomes ineffective.
Adjusting image positions
(AV mode only)
Adjust the horizontal and vertical positions of images on the
Plasma Display.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Position" ( /
4
Select "H/V Position Adjust" ( /
Position
H/V Position Adjust
Reset
5
Adjust the vertical position ( / ) or the horizontal
position ( / ).
6
Press HOME MENU to exit the menu.
NOTE
• To restore the factory defaults for all items, press
select "Reset" in step 4, and then press ENTER. A
confirmation screen appears. Press
then press ENTER.
• Adjustments are stored separately according to input
source.
Adjusting image positions and clock
automatically (PC mode only)
Use Auto Setup to automatically adjust the positions and clock
of images coming from a personal computer.
1
Press HOME MENU.
2
Select "Option" ( /
54
En
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
/
/ to select "Yes", and
then ENTER).
3
Select "Auto Setup" ( /
Option
Auto Setup
Manual Setup
• Auto Setup starts.
4
Press HOME MENU to exit the menu.
NOTE
• When Auto Setup is finished, "Auto Setup completed."
appears.
• Even when "Auto Setup completed" appears, Auto Setup
may have failed, depending on conditions.
• Auto Setup may fail with a PC image composed of similar
patterns or monochrome. If not successful, change the PC
image and try again.
• Be sure to connect the computer to the Media Receiver and
switch it on before starting Auto Setup.
Adjusting image positions and clock
manually (PC mode only)
Usually you can easily adjust the positions and clock of images
using Auto Setup. Use Manual Setup to optimise the positions
and clock of images when necessary.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Manual Setup" ( /
4
Select the item to be adjusted ( /
Manual Setup
H/V Position Adjust
Clock
Phase
Reset
5
Perform adjustment ( /
With "Clock" or "Phase" selected, you can change the
parameter using
6
Press HOME MENU to exit the menu.
NOTE
to
• To restore the factory defaults for all the items, press
select "Reset" in step 4, and then press ENTER. A
confirmation screen appears. Press
then press ENTER.
then ENTER).
then ENTER).
then ENTER).
then ENTER).
0
0
and / ).
/ .
/ to select "Yes", and
/ to