Power Control - Pioneer PureVision PDP-506XDE Mode D'emploi

Basic Adjustment Settings
08

Power Control

Power Control provides convenient functions for power saving.
Energy Save
You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Energy Save" ( /
4
Select "Save 1","Save 2", or "Picture Off" ( /
ENTER).
Item
Standard
Save1
Save2
Picture Off
5
Press HOME MENU to exit the menu.
NOTE
• You can also select this function using the Home menu
when the input source is a PC.
No Signal off (AV mode only)
The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Signal off" ( /
4
Select "Enable" ( /
Item
Disable
(factory default)
Enable
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Media Receiver after a TV
programme finishes.
38
En
then ENTER).
then ENTER).
Description
Does not decrease the picture brightness.
Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Decreases the picture brightness and lowers
power consumption.
Deactivates the screen to save power. To restore
the screen display, press any button other than
i +/i – and e.
This setting is not memorised by the system.
then ENTER).
then ENTER).
then ENTER).
Description
Does not place the system into the standby
mode.
Places the system into the standby mode if no
signal is received for 15 minutes.
No Operation off (AV mode only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Operation off" ( /
4
Select "Enable" ( /
Item
Disable
(factory default)
then
Enable
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
Power Management (PC mode only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Power Management" ( /
4
Select "Mode 1" or "Mode 2" ( /
Item
Off
(factory default)
Mode1
Mode2
5
Press HOME MENU to exit the menu.
then ENTER).
then ENTER).
then ENTER).
Description
Does not place the system into the standby
mode.
Places the system into the standby mode if no
operation is performed for three hours.
then ENTER).
then ENTER).
then ENTER).
Description
No power management
• Places the system into the standby mode
when no signal is received from the personal
computer for eight minutes.
• Even when you start using the computer and
a signal is received again, the system stays
off.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or TV
a on the remote control unit.
• Plac
es the system into the standby mode
when no signal is received from the personal
computer for eight seconds.
• When you start using the computer and a
signal is input again, the system is switched
on.
•
The system is switched on again by pressing
STANDBY/ON on the Media Receiver or TV
unit.
a on the remote control