Connector Principle For The Ptfe Pipe - Ecolab Smart Dose II Rack Manuel D'utilisation

Installation
5.3

Connector Principle for the PTFE Pipe

Fig. 4: Connector Principle for the PTFE Pipe
1 Male stud coupling
2 Clamping ring (grey)
Assembly Instructions:
1. Cut off the PTFE pipe (pos. 4) at a perpendicular angle
2. Press the PTFE pipe (pos. 4) into the male stud coupling (pos. 1), until it stops, Slide
on the clamping ring (pos. 2)!
3. Tighten down the union nuts (pos. 3) by hand, then use the proper size hex wrench
to carefully finish tightening them.
CAUTION!
Make sure the clamping ring (pos. 2) is corrected seated properly!
417102260 Rev. 4-02.2019
3 Union nut
4 PTFE Pipe
28