Initial Switch−On - Lenze L-force EMF2113IB Instructions De Montage

5 Commissioning
Initial switch−on
Initial switch−on
1. The communication module must be attached to the controller (^ 47).
2. Switch on the controller and, if required, the separate voltage supply for the
communication module (^ 49).
3. Check communication module signals:
– The green bus LED indicates the operating status according to the description
under pos. 0 (^ 69).
– The yellow bus LED indicates the communication status according to the
description under pos. 1 (^ 69).
– Quick blinking (8 Hz) is the reaction of the yellow bus LED to impermissible
settings.
4. You can now communicate with the drive.
)
Note!
PCP communication
With a PCP communication the controller parameters can only be accessed
ƒ
after having executed the PCP service "Initiate". After this, the controller
parameters can be accessed with the PCP services "Read" and "Write".
For a detailed description, please see the INTERBUS Communication
ƒ
Manual.
LEDs at the front of the communication module
Please see the notes for the status display (^ 69).
68
l
EDKMF2113 DE/EN/FR 5.1