Starting Production - MBM G2A77XS Instructions Pour Le Fonctionnement

3. 5.
INSTRUCTIONS FOR USE

Starting production

Before proceeding with these operations, see
"Daily activation".
When loading the product into the appliance and
unloading it, there is a residual risk of being burnt;
this risk can occur coming into unintentional
contact with: hob - cooking compartment -
recipients or material processed.
Take appropriate
protection. Wear protective equipment suitable
for the operations to be performed.
The products must be placed in the specific
cooking containers and positioned correctly on
the burners and/or in the cooking compartment of
the oven.
Diameter Pots:
Burner 5.5-7-11 kW Ø mm 200-375
When lighting for the first time, wait for the
possible formation of air inside the gas circuit to
fully escape from the duct.
Solid top: T ≤ 250 ° C (hottest point)
Mijotage: T ≤ 150 ° C (hottest point)
Lighting open burners (Fig. 1)
Turn the knob while holding it in the piezoelectric position
(Detail A Fig.1).
Position a flame (match or something else) on the pilot light
and wait for it to ignite (Fig. 1).
Release the knob after about 20" and check to make sure the
pilot light remains lit.
When the pilot light has been lit, turn the knob (Detail B Fig.1)
to minimum or maximum to adjust the flame.
Hotplate ignition (Fig. 2)
Turn the knob while holding it in the piezoelectric position (Fig.
2 Detail A), and simultaneously press the piezoelectric button
several times (Fig. 2 Detail B) until the pilot light is lit.
Release the knob after about 20" and check to make sure the
pilot light remains lit (Fig. 2).
The pilot light can be seen through the hole on the panel.
When the pilot light has been lit, turn the thermostat knob to
the desired temperature (Fig. 2 Detail C).
Lighting Gas Oven (Fig. 3)
Turn the knob while holding it in the piezoelectric position
(Fig.3 Detail C). Simultaneously press the piezoelectric button
several times (Fig.3 Detail D) until the pilot light is lit.
Release the knob after about 20" and check to make sure the
pilot light remains lit (Fig.3).
The pilot light can be seen through the hole on the oven
top.
When the pilot light has been lit, turn the thermostat knob to
the desired temperature (Fig. 3 Detail E).
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
measures for personal
- 10 - - 10 - 10 10
A
1
Fig.
B
A B
2
Fig.
C
C
A B
3
Fig.