Connections With A Flexpdu (Power Distribution Unit) Module (Optional); Connection With A Hotswap Mbp Module (Optional) - Eaton Pulsar Série Manuel D'installation Et D'utilisation

2. Installation
2.5

Connections with a FlexPDU (Power Distribution Unit) Module (optional)

EX 3000
2.6 Connections with a HotSwap MBP Module (optional)
The HotSwap MBP module makes it possible to service or even replace the UPS without affecting the connected
loads (HotSwap function).
EX 3000
86-86710-00EN A02 - Page 14
1. Connect the UPS powercord (10) to the AC
power source.
2. Connect the input cord of the FlexPDU
module (48) to the UPS outlet (9). The cord
and the outlet are marked in red.
3. Connect the equipment to the outlets (45),
(46) on the FlexPDU module. These outlets
differ, depending on the version of the
FlexPDU module.
1. Connect the input cord (56) of the
HotSwap MBP module to the AC power
source.
2. Connect the UPS input cord (10) to the
"UPS Input" (55) of the HotSwap MBP
module. This cord and the receptacle are
marked blue.
3. Connect the UPS outlet (7) to the "UPS
Output" cord (54) of the HotSwap MBP
module. This cord and the outlet are
marked red.
4. Connect the equipment to the outlets (49)
on the HotSwap MBP module.
Caution:
Do not use UPS outlets (8)and (9) to
supply equipment because use of switch
(53) on the HotSwap MBP module would
cut supply to the equipment. It is advised
not to remove the protective film from
outlets (8) and (9).