Equipment Connections; Connection With A Flexpdu (Power Distribution Unit) Module (Optional) - Eaton Evolution S 1250 RT 2U Manuel D'installation Et D'utilisation

2. Installation
2.5

Equipment Connections

Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source and
the true electrical consumption of the total load.
Evolution S 2500 / S 3000
a
1. Input cable power source.
2. Connect the loads to the UPS. It is preferable to connect the priority loads to the four outlets marked (7) or (9) and
the nonpriority loads to the programmable outlet marked (8).
To program shutdown of outlets (8) during operation on battery power and thus optimize the available backup time.
Fit the connection securing system (rack model only).
*Note: Input cord
NEMA 5-15P for S1250
NEMA 5-20P for S1750/2000
2.6 Connections with a FlexPDU (Power Distribution Unit) module (optional)
Evolution S 2500 / S 3000
FlexPDU
45
86-81710-00EN A03 - Page 14
All manuals and user guides at all-guides.com
46 48
Evolution S 1250 / S 1750 / 2000*
1. Connect the UPS powercord (10) to the AC-power
source.
2. Connect the input cord of the FlexPDU module
(48) to one of the UPS outlets (9).
The cable and the connectors are marked in red.
3. Connect the equipment to the outlets (45) and
(46) on the FlexPDU module. These outlets differ,
depending on the version of the FlexPDU module.