Introduction - Eaton Evolution S 1250 RT 2U Manuel D'installation Et D'utilisation

Thank you for selecting an EATON product to protect your electrical equipment.
The Evolution range has been designed with the utmost care.
We recommend that you take the time to read this manual to take full advantage of the many features of your UPS
(Uninterruptible Power System).
Warning: This is a class A UPS product. In a domestic environment, this product may cause radio interference, in which
case, the user may be required to take additional measures.
If the device must be installed in overvoltage category III or IV environments, additional upstream overvoltage
protection must be provided for.
Before installing Evolution, please read the booklet on the required safety instructions. Then follow the indications in
this manual.
To discover the entire range of EATON products and the options available for the Evolution range, we invite you to
visit our web site at www.eaton.com or contact your EATON representative.
Environmental protection
EATON has implemented an environmental-protection policy.
Products are developed according to an eco-design approach.
Substances
This product does not contain CFCs, HCFCs, or asbestos.
Packing
To improve waste treatment and facilitate recycling, separate the various packing components.
The cardboard we use comprises over 50% of recycled cardboard.
w
Sacks and bags are made of polyethylene.
w
Packing materials are recyclable and bear the appropriate identification symbol.
w
Material
Polyethylene terephthalate
High-density polyethylene
Polyvinyl chloride
Low-density polyethylene
Polypropylene
Polystyrene
Follow all local regulations for the disposal of packing materials.
End of life
EATON will process products at the end of their service life in compliance with local regulations.
EATON works with companies in charge of collecting and eliminating our products at the end of their service life.
Product
w
The product is made up of recyclable materials.
Dismantling and destruction must take place in compliance with all local regulations concerning waste.
At the end of its service life, the product must be transported to a processing center for electrical and electronic waste.
Battery
w
The product contains lead-acid batteries that must be processed according to applicable local regulations concerning
batteries.
The battery may be removed and disposed of in compliance with correct local disposal regulations.
The «Material Safety Data Sheets» (MSDS) for the batteries are available on our web site*.
(*) For more information or to contact the Product Environmental manager, please visit our website: www.eaton.com.
All manuals and user guides at all-guides.com
Abbreviation
PET
HDPE
PVC
LDPE
PP
PS

Introduction

01
PET
Symbol
01
number
PET
01
02
03
04
05
06
86-81710-00EN A03 - Page 5