Climate / Temperature Class; Electrical Connection - Gram COMPACT 220 Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 62

Climate / temperature class

Products are tested according to the following climate and temperature classes.
Information about the product's climate and temperature class can be found on the name
plate (see fig.6)
Climate class
3
4

Electrical connection

Read the text below thoroughly before electrical connection.
Connect the power cord found at the back of the cabinet to main supply inlet (see fig 6).
The product is intended for connection to alternating current. The connection
voltage (V) and frequency (Hz) are shown on the name plate in the cabinet (see
Fig.6). Only the supplied cord is to be used.
Never use an extension cord for this appliance!
If a wall socket is placed in a longer distance than the length of the supplied power
cord, contact an electrician to establish a wall socket within the range of the
supplied power cord.
If the product is defective, it must be examined by a properly skilled technician
with proper knowledge of the product during the warranty period.
Outside the warranty period, it is advisable to use the service advised by your
dealer. If this is not the case, assistance is required from a properly skilled
technician with proper knowledge of the product.
Always disconnect the power if interruptions in power supply occur, and when electrical
parts are removed/put on, and before cleaning and maintenance of the product.
Repairing of electrical/technical parts may only be performed by properly skilled technicians
with proper knowledge of the product.
Do not use the product before all coverings are installed, so that live or rotating machine
parts cannot be touched.
The product is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed.
The plug and wall socket should then give correct earthing. If necessary, contact an
electrician.
Make sure the product is switched off at the socket before service is
performed on electrical parts. It is not sufficient to switch off the product
by the START/STOP key as there will still be voltage to some electrical
parts of the product.
765042402
25°C / 60 % RH
30°C / 55 % RH
Rev. 000
Temperature
class
L1
M1
-18°C
+5°C
33

Publicité

Table des Matières
loading

Table des Matières