Gram COMPACT 220 Série Mode D'emploi page 29

COMPACT 220/320/420 with castors or legs:
The cabinet is tilted slightly backward, and the front part of the pallet can be removed.
Then the cabinet is tilted slightly forward, and the rear part can be removed. (see Fig.2)
This task requires at least 2 persons.
Fig.1
If the cabinet has been transported in horizontal position it must stand upright at
least 2 hours before it is started to allow the oil from the compressor to run back.
Because of the heavy weight of the product, the floor might be damaged or
scratched when moving the product.
Correct set up gives the most effective operation.
The product should be located in a dry and adequately ventilated room.
To ensure efficient operation, it may not be placed in direct sunlight or against
heat-emitting surfaces. The product is designed to operate in an ambient
temperature between +16C and +30°C.
Avoid placement of the product in a chlorine/acid-containing environment
(swimming bath etc.) due to risk of corrosion.
Parts of the product is equipped with a protecting film, which should be removed
before use.
Clean the product with a mild soap solution before use.
765042402
Fig. 2
Rev. 000 29