Remove The Machine From Storage - Toro 20899 Mode D'emploi

G020809
Forward Position
1. With the handle in the upright position, step on the
foot pedal and hold it down.
2. Move the handle all the way forward and loosen the
upper handle knob
3. To unfold the handle, refer to
(page 5).
Figure 52
(Figure 53).
Figure 53
1 Unfolding the Handle
Remove the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly by
pulling the recoil-start handle to blow the excess oil
from the cylinder.
3. Install the spark plug and tighten it with a torque
wrench to 20 N-m (15 ft-lb).
4. Perform any maintenance procedures; refer to
Maintenance (page
5. Check the engine-oil level; refer to
Engine-Oil Level (page
6. Fill the fuel tank with fresh gasoline; refer to
Fuel Tank (page
7. Connect the wire to the spark plug.
21
16).
Checking the
10).
9).
Filling the