Special Safety Instructions - Ayce 1515 Traduction De La Notice Originale

f) Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
5) Service
a) Have your power tool serviced by qualified repair person using only
identical replacement parts. This will ensure that the safety of the power tool
is maintained.
b) If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.

SPECIAL SAFETY INSTRUCTIONS

1. Wear ear protectors with impact drills. Exposure to noise can cause
hearing loss.
2. Use auxiliary handles supplied with the tool. Loss of control can cause
personal injury.
3. Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the operator an electric shock.
4. If possible, always use clamps or a vice to hold your work.
5. Always switch off before you put the drill down.
6. Ensure that the lighting is adequate.
7. Do not put pressure on the drill, such that it slows the motor down. Allow the
drill bit to drill without pressure. You will get better results and you will be
taking better care of your tool.
8. Keep the area free of tripping hazards.
9. Do not let anyone under 18 years operate this tool.
10. Only use accessory bits in good condition.
11. Before drilling, check that there is sufficient clearance for the drill bit under
the workpiece.
12. Do not touch the bit after operation. It will be very hot.
13. Keep your hands away from under the workpiece。
14. Never use your hands to remove dust, chips or waste close by the bit.
15. Rags, cloths, cord, string and the like should never be left around the
work area.