Emergency Stopping; Operation - Nilfisk T40PLUS Manuel D'instructions

T40PLUS - T40WPLUS
GB
C380
Low compressed air pressure
Manual-Automatic
Run-Vacuum
Product outlet full
Voltage presence
Circuit breaker guard
Filter Cleaning
Reset
Safety devices reset
Exchanger
Container outlet
Silo-hopper outlet
Separator full

Emergency stopping

Turn the switch to "0" to turn off the machine.
The motors and internal components of the machine
will still be electrically powered.
Close the on/off valve. The machine stops.

Operation

Vacuum gauge (2): green zone (3), red zone (1)
When using the machine, check the flow control:
■ when the machine is operating, the pointer of the vacuum
gauge must remain in the green zone (3) to ensure that
the speed of the intake air does not drop below the safety
value of 20 m/sec;
■ If the pointer is in the red zone (1) it means that the speed
of the air in the vacuum hose is less than 20 m/s, and that
the machine is not operating in optimal conditions. Shake
or replace the filter.
■ during normal operation conditions, close the vacuum
hose, the pointer of the vacuum gauge must switch from
the green zone (3) to the red zone (1).
When the machine is operating, always check that the
vacuum gauge pointer remains in the green zone (3).
Consult the "Troubleshooting" chapter if faults occur.
10
Phase sequence
Silo-hopper full
Silo-hopper
Overtemperature
Start
Stop
CAUTION!
Figure 8
CAUTION!