Informations For Energy-Saving Use; Tips - V-ZUG ROYAL 51018 Mode D'emploi

Informations for energy-saving use

As far as possible, use the cooling unit in
n
its as-delivered state. The arrangement
of drawers, shelves and trays ensures the
best possible temperature distribution.
Do not install the unit near radiators,
n
radiator pipes or smoke extractors and
protect it as far as possible from direct
sunlight
Make sure the unit doors are kept open
n
for as short a time as possible. The
quicker the doors are closed again, the
less cold is lost.
Make sure that the doors are closed fully
n
and correctly. The door seal must be
flush against the frame of the fridge.
Leave warm or even hot items to cool
n
down outside the unit.
The storage of moisture-releasing food-
n
stuffs leads to increased build-up of ice
on the rear of the fridge and a reduction
in cooling power.

Tips

The following points should be noted
when using the new appliance:
A appliance which has just been put into
n
use needs approx. 15 hours (with pro-
ducts) until it has reached its normal
operating temperatures.
If the doors are open for longer than 2
n
minutes then the lamp starts to flash.
Make sure after closing that the doors
are fully sealed. The self-closing hinges
assist this.
The cooling time for beverages and other
n
products can take up to 6 hours from
room temperature down to the cold
room temperature. The warmer they are
when put in, the longer this time will be.
46
Re-setting the temperature control has
n
no effect on the cooling rate, only on
the temperature reached.
Condensation can form on the glass
n
shelves if products are stored which emit
water vapour.
The electronic control defrosts the cold
n
room only about once per day. A cat ice
may be visible oftentimes at the back
board of the cold room – this is though
normal.
Be careful that products do not come
n
into contact with the rear wall of the
cold room so that they do not freeze to
it and that, during defrosting, water
does not get diverted into the cold
room.
When filling be careful that:
n
– Oil and fats do not come into contact
with the polymer parts and the door
seals.
– The coldest locations in the cold room
for any setting of the temperature
controller are at the back wall and
above the lowest shelf. Sensitive pro-
ducts should therefore be put on the
lowest shelf.