Important Installation Information - Thermador P24GE Mode D'emploi

Important Installation Information

This appliance has been
tested in accordance with ANSI
Z21.1, Standard for Household
Cooking Appliances (USA) and
in accordance with CAN 1.1-
M81 Domestic Gas Ranges
(Canadian).
It is strongly recommended
that this appliance be installed
in conjunction with a suitable
overhead vent hood. (See Step
1 for Ventilation Requirements.)
Due to the high heat capability
CAUTION
To eliminate risk of burns or
fire caused by reaching over
heated surface units, cabinet
storage located above the
surface units should be
avoided.
of this unit, particular attention
should be paid to the hood and
duct work installation to assure it
meets local building codes.
Check local building codes for
the proper method of appliance
installation. Local codes vary.
Installation, electrical connections
and grounding must comply with
all applicable codes. In
absense of local codes the
appliance should be installed
CAUTION
(1) When connecting the unit to
propane gas, make certain
the propane gas tank is
equipped with its own high-
pressure regulator in addition
to the pressure regulator
supplied with this unit. The
maximum gas pressure
to this appliance is not to
exceed 14.0 inches water
column from the propane
gas tank regulator.
(2) This unit is designed as a
cooking appliance. Based
on safety considerations,
never use it for warming or
heating a room.
2
in accordance with the National
Fuel Gas Code ANSI Z223.1
current issue and National Gas
Code ANSI/NFPA 70 – current
issue. In Canada, installation
must be in accordance with
the CAN 1-B149.1 and .2 –
Installation Codes for Gas
Burning Appliances and/or local
codes.
the
This appliance is equipped
with an intermittent/interrupted
ignition device that cycles the
two far left surface burners on
and off when in the ExtraLow
setting.
®