Step 6: Backguard Installation - Thermador P24GE Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A Low Back backguard must be installed
when there is less than a 12" clearance
between combustibles and back edge of
cooktop. (See Fig. 1 and 5.) For island
installations and other installations with
over 12" clearance, an optional stainless
steel trim channel is available to cover the
backguard mounting flanges. Attach the
backguard before sliding the appliance
into the final installed position. Follow
Steps A through C below:
A. Slide backguard over the two flanges
on the rear of the appliance. Fasten
the front and back with the two screws
(see A, Fig. 12) provided.
B. Fasten the top of the backguard to
the wall with two screws through the
backguard. (See B, Fig. 12.)
C. Place the backguard cap on top and
fasten using the two counter-sink
screws provided. (See C, Fig. 12.)
LOW BACK AND ISLAND TRIM MODEL NUMBERS
COOKTOP MODEL NO.
P24GE
P24WK
PC304
PC36
PC48
*Requires a minimum of 12" horizontal clearance between back of appliance and combustible materials.
TO CLEAN AND PROTECT EXTERIOR SURFACES
The stainless steel surfaces may be cleaned by
wiping with a damp soapy cloth. Any mild glass
cleaner will remove fingerprints and smears.
Follow all cleaning by rinsing with clear water. Wipe
dry with a clean soft cloth to avoid water marks.
For discolorations or deposits that persist, use a
non-scratching household cleanser or stainless
steel polishing powder with a little water and a soft
cloth. For stubborn cases, use a plastic scouring
pad or soft bristle brush together with cleanser and
water. Rub lightly in direction of polishing lines or
"grain" of the stainless finish. Avoid using too much
pressure which may mar the surface.

Step 6: Backguard Installation

FIG. 12 Low Back Attachment
12" LOW BACK
PC24LB
GP24LBS
PC30LB
GPS36LBS
GPS48LBS
C
B
A
Island Trim*
GP24ITS
GPS36ITS
GPS48ITS
Use a stainless steel cleaner/polish to protect the
finish and maintain appearance.
DO NOT allow deposits to remain for long periods
of time.
DO NOT use ordinary steel wool or steel brushes.
Small bits of steel may adhere to the surface
causing rust.
DO NOT allow salt solutions, disinfectants, bleaches
or cleaning compounds to remain in contact with
stainless steel for extended periods. Many of these
compounds contain chemicals which could prove
harmful. Rinse with water after exposure and wipe
dry with a clean cloth.
12
PC24IT
PC30IT

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

P24wkPc304Pc36Pc48

Table des Matières