Assembly; Saddle Height - SQlab M-D Serie Mode D'emploi

Assembly

Warning
Incorrectly mounted components pose a significant risk.
• You must read and understand the instructions and notes in the manual before you begin the assembly.
• If you have questions about mounting these components, contact your SQlab dealer or have your saddle fitted by an experienced
bicycle mechanic.
Caution
To fit out an eMTB, eBike and pedelec, certain country-specific standards, rules and regulations must be followed.
• In Germany, observe the "Guide to Conversion to Pedelecs" of the Zweirad-Industrie-Verband e.V.
(http://www.ziv-zweirad.de) in cooperation with the association service and bicycle geV (www.vsf.de) and Zedler -
Institute for Bicycle Technology and Safety GmbH (www.zedler.de).
• The M-D Line saddles have not received blanket approval for fast pedelecs (S-pedelecs, up to 45 km/h). Observe
the country-specific specifications for these. In Germany, particularly the "Guidelines for component replacement on
fast e-bikes/pedelecs with pedal assistance up to 45 km/h" must be observed.

Saddle height

Information on the correct saddle height adjustment can be found in the manual for your bike and in a number of books and guides on
bicycle ergonomics. Your SQlab dealer will certainly be happy to help you.
Due to the SQlab step saddle concept, SQlab saddles usually build a little higher than other saddles. Therefore, after replacing the sadd-
le, it is necessary to check and possibly correct the saddle height adjustment.