Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DUE TO VARYING ANGLES OF VEHICLE SEAT
BELT RETRACTORS, EXCESS SLACK IN THE
VEHICLE BELT SYSTEM MIGHT NOT BE REMOVED
AUTOMATICALLY. Once the lap and shoulder portions
of the seat belt are properly positioned and the
buckle is attached, FEED ANY REMAINING SLACK
OF THE SEAT BELT MANUALLY BACK INTO THE
RETRACTOR TO TIGHTEN THE WHOLE SYSTEM.
BOOSTER WITHOUT BACKREST
See
"Assembling/Disassembling
(pg. 19) for instructions for removing the backrest. Once
backrest is removed, turn recline knob clockwise until
end is reached to retract the base plate on the bottom
of the seat.
1. Place the booster seat firmly against the back of a
forward-facing vehicle seat in a position equipped
with a vehicle 3-point lap-and-shoulder belt and
headrest. Booster must be level, stable and not rock
side-to-side (see "Choosing an appropriate vehicle
seat location", pg. 12).
2. Have your child sit on the booster seat with their back
flat against the vehicle seat.
3. Thread both sides of the lap belt and
the lower end of the shoulder belt
UNDER BOTH armrests as indicated
and ensure that the lap belt is snug
across child's hips just touching
their thighs and is NOT across their
stomach.
4. Buckle vehicle seat belt into place and ensure it is
secure by gently pulling on it.
!
THE LAP BELT PORTION MUST PASS UNDER BOTH
ARMRESTS.
WARNING!
!
child
restraint"
40
Publicité
Chapitres
Table des Matières
