Using Child Restraint In Booster Mode; (Without Internal Harness); Removing/Installing Harness - Harmony DEFENDER 360 Manuel D'instructions

USING CHILD RESTRAINT IN BOOSTER MODE

(WITHOUT INTERNAL HARNESS)

REMOVING/INSTALLING HARNESS

1. Open chest clip and harness buckle.
2. Face the rear of the child restraint and remove the
harness straps from the splitter plate ❶.
3. Pull shoulder straps out of their respective slots in the
backrest ❷.
4. Lie child restraint on its side and find the metal
locking plate for each harness strap on the underside
of the base of the child restraint. Place a screwdriver
under the loop of the strap and pry up to unlock
the metal locking plate from the plastic base ❸.
Turn each metal plate so that it
can slide up and out through the
plastic seat base.
5. Repeat procedure for top tether
removal.
6. Store complete harness system for
future use.
7. Store crotch buckle under fabric
seat pad in the indentation in the
plastic seat base ❹.
8. Pull the
adjustment strap as far as it will
go. This will lock the splitter plate
into the base of the seat ❺.
9. Roll strap tightly, secure roll with
an elastic band and store rolled
strap under the fabric seat pad in the opening of the
up-front adjuster.
35
❶
up-front
❷
harness
❸
❹
❺