Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To engage vehicle seat belt retractor:
4. Pull out the full length of the seat
belt (until you cannot pull out
any more slack). This locks the
retractor.
5. Tighten vehicle seat belt by placing
your knee on the seat base and by
using your full weight to push the
child restraint down ❹ as you
simultaneously release the extra
belt length until seat belt is taunt
and has no slack ❺.
6. The locked seat belt retractor will
not allow you to add any length
to the belt until you unbuckle the
seat belt.
For more information on how to tighten the belt for
your seat belt system, see your vehicle owner's manual.
7. Secure the top of the child restraint using the top
tether strap (see section "Using top tether", pg. 23).
INSTALLATION SAFETY CHECK
Perform this test EVERY TIME you drive with your child
and whenever you readjust the child restraint as your
child grows:
Rock the child restraint back and
forth and side to side to make sure
the UAS or vehicle seat belt does not
lengthen or loosen, and the child
restraint does not move easily ❶.
The back of the child restraint (connection point) should
not move more than 1 inch (2.5 cm) in any direction.
Check to ensure that side bolts and backrest connector
rod are tightly secured.
31
❸
❺
❹
❶
Publicité
Chapitres
Table des Matières
