Installing Child Restraint In Harness Mode: Uas Or Vehicle Seat Belt - Harmony DEFENDER 360 Manuel D'instructions

Pass the
(22.3
rod through
Insert the washer and
0.5 inch (1.2 cm) screw
on opposite side and
tighten ❹.
TIP: If connector rod does not pass through easily, make
sure it is aligned with holes and tap screw head
lightly to guide it through the plastic.
! WARNING: Ensure that all THREE connection points
are secure and tight. DO NOT over tighten.
CHECK FREQUENTLY.
INSTALLING CHILD RESTRAINT IN HARNESS
MODE: UAS OR VEHICLE SEAT BELT
You can install the child restraint using EITHER the UAS
or vehicle seat belt.
UAS: The lower Universal Anchorage System (UAS) is
used for installing the child restraint WITHOUT using
the vehicle seat belts.
! The UAS can ONLY be used if your vehicle has the
UAS anchors installed and designated UAS seating
positions. Check your vehicle owner's manual to see
which seating positions may be equipped with UAS.
Vehicle Seat Belts: If UAS is not an option, you MUST
use the vehicle seat belt to install the child restraint in
your vehicle.
8.8
cm) connector
assembly.
inch
Connector
screw
Backrest
anchor points
❹
Base
plate
20