Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TO INSTALL
To reinstall fabric pads, repeat previous steps in reverse
order.
TIP: For ease of fabric pad installations, turn recline knob
counterclockwise to open gap at base of backrest to
facilitate passing the hook and loop tabs through
the gap to secure.
!
CAUTION: Reinstall harness system if applicable
(see "Removing/Installing harness", pg. 35).
1. The cup holder can be installed on either side of the
child restraint.
2. Locate the opening in the end of
either armrest.
3. Insert cup holder clip into the
opening and push in until locked
into place. Ensure that the fabric
does not interfere with the
installation. If so, gently pull down
on the fabric while installing cup holder.
4. Pull out to remove.
CLEANING YOUR SEAT PAD:
• MACHINE WASH SEPARATELY using cold water -
delicate cycle.
• DO NOT BLEACH.
• DRIP DRY to prevent cover from shrinking.
!
DO NOT wash EPE foam pad insert in backrest.
CLEANING THE PLASTIC SHELL:
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY.
INSTALLING CUP HOLDER
(WHEN APPLICABLE)
CARE AND MAINTENANCE
44
Publicité
Chapitres
Table des Matières
