Device Warm-Up - Philips RESPIRONICS SimplyGo Mini Mode D'emploi

SimplyGo Mini User Manual
Note: The AC Power Supply is equipped with a green light, which illuminates
as soon as you connect the device to an energized AC power source�
4� When charging is complete (this takes four hours or less for the
standard battery), disconnect the AC Power Supply and store it with
the AC Power Cord for future use�
Note: Replacement and spare batteries are available separately� For
information, contact your equipment provider�
Note: An optional SimplyGo Mini Smart Battery Charger (sold separately)
is available for your system� For more information, contact your
equipment provider�

Device Warm-Up

When you turn on your SimplyGo Mini device, it will sense if you are breathing
from it� If you are not yet breathing through the cannula, SimplyGo Mini will
begin to pulse automatically about once every five seconds� As soon as you
begin breathing through the cannula, the device will begin delivering pulses
based on your breathing� It may take up to 20 minutes for the SimplyGo Mini
output to stabilize within its O
breathing from the SimplyGo Mini at any time� During the initial stabilization
period, the Warm-Up symbol is displayed under the setting number�
Note: If the device is stored at the minimum storage temperature between
uses, please allow 2�5 hours for the unit to adequately warm up�
Note: If the device is stored at the maximum storage temperature between
uses, please allow 2�5 hours for the unit to adequately cool down�
Note: The Low Oxygen Concentration Alarm is inactive for approximately 20
minutes after startup� The No Breath Alarm is inactive for the first ten
minutes after startup�
16
purity specifications� However, you may begin
2